PRE-RELEASE

Cylinder Head Installation - Left Side

EN 49411 Torque Angle Sensor Kit

For equivalent regional tools, refer to Special Tools .

Ensure the cylinder head locating pins are securely mounted in the cylinder block deck face.

Install a NEW cylinder head gasket bank 2 using the deck face locating pins for retention.

Align the cylinder head bank 2 with the deck face locating pins.

Place the cylinder head bank 2 in position on the deck face.

Refer to Fastener Caution .

Note
•	DO NOT allow oil on the cylinder head bolt bosses.
•	DO NOT reuse the old cylinder head bolts.

Install NEW 8 cylinder head bolts.

4.1.

Tighten the 8 NEW cylinder head bolts a first pass in sequence to 30 Nm (22 lb ft) .

4.2.

Tighten the NEW 8 cylinder head bolts a second pass in sequence to an additional 120 degrees using the EN 49411 angle sensor.