PRE-RELEASE

Cylinder Head Installation - Right Side

EN 49411 Torque Angle Sensor Kit

For equivalent regional tools, refer to Special Tools .

Ensure the cylinder head locating pins are securely mounted in the cylinder block deck face.

Install a NEW cylinder head gasket bank 1 using the deck face locating pins for retention.

Align the cylinder head bank 1 with the deck face locating pins.

Place the cylinder head bank 1 in position on the deck face.

Note
•	DO NOT allow oil on the cylinder head bolt bosses.
•	DO NOT reuse the old cylinder head bolts.

Install NEW 8 cylinder head bolts.

Refer to Fastener Caution .

Tighten the NEW 8 cylinder head bolts:

5.1.

First pass in sequence to 45 Nm(33 lb ft) .

5.2.

Tighten the second pass in sequence to an additional 120 degrees using the EN 49411 angle sensor.