PRE-RELEASE
Oil Pan Installation
| Oil Pan Installation |
Special Tools
EN 46109 Guide Pin SetFor equivalent regional tools, refer to Special Tools .
| 1. |
Install the 8 mm (0.315 in) guides from the
EN 46109
guide pin into the center oil pan rail bolt hole on each side of the engine block.
|
|
| 2. |
Place a 3 mm (0.118 in) bead (1) of RTV sealant, on the block pan rail and the crankshaft rear oil seal housing. Refer to
Adhesives, Fluids, Lubricants, and Sealers
for the recommended sealant.
|
|
| 3. |
Position the oil pan onto the block.
|
|
| 4. |
Remove the
EN 46109
guide pin 8 mm (0.315 in) guides from the engine block.
|
|
| 5. |
Loosely install the 11 oil pan bolts at cylinder block.
|
|
| 6. |
Loosely install the 2 oil pan bolts at crankshaft rear oil seal housing.
|
|
| 7. |
Refer to
Fastener Caution
.
Tighten the oil pan bolts in sequence as shown: 
|
|
| 7.1. |
Tighten the 8 mm (0.315 in) bolts (1-11) to
23 Nm (17 lb ft)
a first pass in sequence.
|
| 7.2. |
Tighten the 8 mm (0.315 in) bolts (1-11) to
23 Nm (17 lb ft)
a second pass in sequence.
|
| 7.3. |
Tighten the 6 mm screws (0.236 in) (12, 13) to
10 Nm (97 lb in)
.
|
