Fuel Pressure Gauge Installation and Removal
|
|
Fuel Pressure Gauge Installation and Removal
|
|
Callout
|
Component Name
|
Preliminary Procedure
Remove the engine sight shield. Refer to
Engine Sight Shield Replacement
.
|
1
|
Fuel Pressure Test Check Retainer
Warning
|
|
Always apply a few drops of clean engine oil to the male pipe ends before connecting the fuel pipe fittings in order to reduce the risk of fire and personal injury. This will ensure proper reconnection and prevent a possible fuel leak. During normal operation, the O-rings located in the female connector will swell and may prevent proper reconnection if not lubricated.
|
|
|
|
|
|
|
2
|
Fuel Pressure Test Check
Procedures
|
1.
|
Install
EN-34730-91 tester
.
|
|
2.
|
Remove the air from the pressure tester.
|
|
4.
|
The set point are
380 kPa +/- 20 kPa ( 3,8 bar +/- 0,2 bar )
|
Special Tools
EN-34730-91
Pressure Tester
For equivalent regional tools, refer to
Special Tools
.
|
