Headlamp High Beam Control Module Programming and Setup
|
|
Headlamp High Beam Control Module Programming and Setup
|
The following service procedures require either a programming or a setup event performed for a complete repair.
|
Headlamp High Beam Control Module Replacement
|
If the headlamp high beam control module needs to be replaced, the following procedures must be performed:
|
2.
|
Perform the SPS function Headlamp High Beam Control Module - Configuration & Setup and follow the on-screen instructions. On the screen Control Module - Configuration and Setup Function(s), select both control module Configuration/Reconfiguration and the appropriate control module Setup.
|
|
3.
|
Clear DTCs after completing the programming procedure.
|
|
Headlamp High Beam Control Module Reprogramming
|
This device requires no programming.
