SAAB WIS ONLINE

PRE-RELEASE

Generator Replacement (LAU/A28NER)

Generator Replacement (LAU/A28NER)



Callout Component Name

Preliminary Procedure

1. Remove the secondary air injection inlet pipe. Refer to Secondary Air Injection Pump Replacement .

2. Remove the charge air cooler outlet hose. Refer to Charge Air Cooler Outlet Hose Replacement (Diesel) Charge Air Cooler Outlet Hose Replacement (LAU/A28NER) .

3. Drain the cooling system. Refer to Cooling System Draining and Filling (LDK/A20NTH) Cooling System Draining and Filling (LBS/A20DOTH) Cooling System Draining and Filling (LAUE/A28NEAR) .

4. Remove the drive belt from the pulley belt idler. Refer to Drive Belt Replacement .

5. Remove the front bumper fascia center support bracket. Refer to Front Bumper Fascia Center Support Bracket Replacement .

6. Remove the radiator upper bracket. Refer to Radiator Replacement (Diesel) Radiator Replacement (LDK/A20NHT) Radiator Replacement (LAU/A28NER) .

7. When replacing, check the battery, see Battery checking/testing and recharge the battery if necessary, see Battery charging .


1

Generator Pulley Belt Idler Fastener

Refer to Fastener Caution .

Tighten

15 Nm (11 lb ft)

2

Generator Pulley Belt Idler

3

Generator Wiring Harness Connector


Procedure

1. Disconnect the electrical connector.

2. Remove the wiring harness fastener.


4

Generator Fastener (Qty: 2)

Tighten

35 Nm (25 lb ft)

5

Generator


Procedure

1. Remove the charge air cooler outlet duct bracket.

2. Remove the engine oil cooler hose from engine oil cooler pipe.




PRE-RELEASE