Bosch Connectors (2.8 JPT)
|
|
Bosch Connectors (2.8 JPT)
|
Special Tools
For equivalent regional tools, refer to
Special Tools
.
|
Terminal Removal Procedure
|
|
1.
|
Pull out the slider on the connector position assurance (CPA) until it is at the end of its travel.
|
|
2.
|
Disconnect the connector from the component.
|
|
3.
|
Remove the wire dress cover, if necessary.
|
|
4.
|
Push the wire side of the terminal that is being removed toward the connector and hold it in position.
|
|
5.
|
Insert the EL-38125-557 into the 2 cavities on each side of the terminal at the front of the connector and push until you feel the tool disengage the terminal retainers.
|
|
6.
|
Carefully pull the terminal out of the connector. Always remember never use force when pulling a terminal out of a connector. If the terminal is difficult to remove, repeat the entire procedure.
|
|
2.
|
Find the appropriate terminated lead.
|
|
3.
|
Use the appropriate splice sleeves depending on the gauge size.
|
