PRE-RELEASE
Yazaki Connectors (16-Way)
| Yazaki Connectors (16-Way) |
Special Tools
For equivalent regional tools, refer to Special Tools .| Removal Procedure |
| 1. |
While depressing the lock, pull the two connector halves apart.
|
|
| 2. |
Use a small flat-blade tool to very carefully push the terminal position assurance (TPA) towards the face of the connector on both sides of the connector. |
|||||||
| 3. |
View of the male half of the connector with female terminals.
|
|
| 4. |
View of the female half of the connector with male terminals.
|
|
| 5. |
Use the EL 38125-215 tool to release the terminals by inserting the tool into the terminal release cavity.
|
|
| 6. |
View of the female half of the connector with male terminals.
|
|
| 7. |
View of the male half of the connector with female terminals.
|
|
| 8. |
While holding the removal tool in place, gently pull the wire out of the back of the connector. Always remember never use force when pulling a terminal out of a connector.
|
|
| Terminated Lead Repair |
| 1. |
Remove the terminal.
|
|
| 2. |
Find the appropriate terminated lead.
|
|
| 3. |
Use the appropriate splice sleeves depending on the gauge size.
|
|
| 4. |
Refer to
Splicing Copper Wire Using Splice Sleeves
|
|
