SAAB WIS ONLINE

PRE-RELEASE

Brake and Accelerator Pedal Assembly Replacement (Left Hand Drive)

Brake and Accelerator Pedal Assembly Replacement (Left Hand Drive)



Callout Component Name

Preliminary Procedure

1. Remove the front floor console. Refer to Front Floor Console Replacement .

2. Remove the Instrument Panel Outer Trim Cover. Refer to Instrument Panel Outer Trim Cover Replacement - Left Side .

3. Remove the windshield side garnish molding. Refer to Windshield Side Garnish Molding Replacement .

4. Remove the front and rear side door sill trim plate. Refer to Front and Rear Side Door Sill Trim Plate Replacement .

5. Remove two fasteners to the power vacuum brake booster. Refer to Power Vacuum Brake Booster Replacement (Left Hand Drive) Power Vacuum Brake Booster Replacement (Right Hand Drive) .

6. Remove the steering column. Refer to Steering Column Replacement .

7. Release the hood release handle and release the instrument panel tie bar and lift it out and secure the tie bar approx. 40 mm out, on the left side of the car. Refer to Instrument Panel Tie Bar Replacement .


Note

The fasteners to the pedal assembly need to be removed before the tie bar is released.


1

Brake and Accelerator Pedal Assembly Fastener (Qty: 7)

Refer to Fastener Caution .

Tighten

22 Nm (16 lb ft)

2

Brake and Accelerator Pedal Assembly


Procedures

1. Disconnect the electrical connectors.

2. Release the brake pedal from the pushrod, by pulling the pedal backwards.

3. Install NEW click fit connector on brake pedal arm.




PRE-RELEASE