SAAB WIS ONLINE

PRE-RELEASE

Power Steering Pressure Pipe/Hose Replacement (L4)

Power Steering Pressure Pipe/Hose Replacement (L4)



Callout Component Name

Preliminary Procedure

1. Place drain pans under the vehicle.

2. Remove as much power steering fluid from the remote power steering fluid reservoir as possible.

3. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .


1

Power Steering Pressure Pipe/Hose Retainer

Refer to Fastener Caution .

Procedures

Install a NEW power steering gear inlet hose O-ring seal and moisture with steering gear fluid, prior to installation of the hose.

Tighten

37.5 Nm (28 lb ft)

2

Power Steering Pressure Pipe/Hose Clip (Qty: 2)

3

Power Steering Pressure Pipe/Hose Bracket Bolt

Tighten

9 Nm (80 lb in)

4

Power Steering Pressure Pipe/Hose


Procedures

1. Install NEW steering gear oil seals and moisture with steering gear fluid.

2. Fill and bleed the power steering system. Refer to Power Steering System Bleeding .

3. Clean any excess power steering fluid from the vehicle.




PRE-RELEASE