SAAB WIS ONLINE

PRE-RELEASE

Strut Assembly Replacement (GNB)

Strut Assembly Replacement (GNB)



Callout Component Name

Preliminary Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .

2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .

3. Support the lower control arm, using a suitable jack stand.

4. Disconnect the damper electrical connector.

5. Remove the stabilizer shaft link from the front strut. Refer to Stabilizer Shaft Link Replacement (GNA) Stabilizer Shaft Link Replacement (GNB) .


1

Lower Strut Fastener

Refer to Fastener Caution .

Procedures

Install NEW bolt. The bolt head must face the side shown in the graphic.

Tighten

70 Nm ±10 Nm (52 lb ft ± 7 lb ft)

2

Upper Strut Fastener

Procedures

Use the CH-8996662 sleeve and CH-49375 wrench to hold the upper fastener.

Tighten

45 Nm (33 lb ft)


Special Tools

• CH-8996662 Sleeve

• CH-49375 Wrench


For equivalent regional tools, refer to Special Tools .

3

Strut Assembly

Procedures

For servicing the individual strut components, refer to Strut, Strut Component, or Spring Replacement .



PRE-RELEASE