SAAB WIS ONLINE

PRE-RELEASE

Engine Block Assemble (LDK, LHU)

Engine Block Assemble (LDK, LHU)



1.
Note

Apply sealant to all plugs prior to installation.


Install the drain plug with sealant in the water pump. Refer to Adhesives, Fluids, Lubricants, and Sealers (LDK, LHU) .


2. Refer to Fastener Caution .

Install the coolant jacket plugs with sealant and tighten to 35 Nm (26 lb ft) .

2.1. Install the rear oil channel plugs (3) with sealant and tighten to 60 Nm (44 lb ft) .

2.2. Install the other oil channel plugs (1,2) with sealant and tighten to 35 Nm (26 lb ft) .

3. Lubricate the crankshaft position (CKP) sensor O-ring with clean engine oil. Refer to Adhesives, Fluids, Lubricants, and Sealers (LDK, LHU) .


4. Install the CKP sensor (1) and bolt and tighten to 10 Nm (89 lb in) .

5. Install the oil pressure switch (2) and tighten to 26 Nm (19 lb ft) .

6. Install the knock sensors (1) with the bolts and tighten to 25 Nm (18 lb ft) .


7. Install the piston's oil jets (1) and tighten to 15 Nm (11 lb ft) .



PRE-RELEASE