PRE-RELEASE
Camshaft Cover Assemble
| Camshaft Cover Assemble |
Special Tools
| • |
DT 5590
Bearing and Seal Driver
|
|
| • |
J-25254-A
Oil Seal Installer
|
|
For equivalent regional tools, refer to Special Tools .
| Left Camshaft Cover |
| 1. |
Install the NEW left spark plug shield tube seals using the
DT 5590
driver (1) and
J-25254-A
installer (2).
|
|
| 2. |
Install the NEW left camshaft cover gasket.
|
|
| 3. |
Install the oil fill tube (3) and oil fill tube O-ring (4) if a NEW camshaft cover and oil fill tube are being assembled. Lightly lubricate the O-ring with engine oil before inserting the oil fill tube into the camshaft cover. Make sure the tube is fully seated into both retaining tangs.
|
|
| 4. |
Install the oil fill cap (1) and NEW O-ring (2).
|
|
| 5. |
Refer to
Fastener Caution
.
Install the fuel injector sight shield cover ballstud (1) and tighten to 10 Nm (89 lb in) . 
|
|
| 6. |
Install the NEW left camshaft cover bolt grommets (1). 
|
|||||||
| Right Camshaft Cover |
| 1. |
Install the NEW right spark plug shield tube coil seals using the
DT 5590
driver (1) and
J-25254-A
installer (2).
|
|
| 2. |
Install the NEW right camshaft cover gasket.
|
|
| 3. |
Install the NEW right camshaft cover bolt grommets. 
|
|||||||
