PRE-RELEASE
Crankshaft Rear Oil Seal and Housing Installation
| Crankshaft Rear Oil Seal and Housing Installation |
Special Tools
| • |
EN-42183
Handle
|
|
| • |
EN-46109
Guide Pin Set
|
|
| • |
EN-47839
Crankshaft Rear Oil Seal Installation Tool
|
|
For equivalent regional tools, refer to Special Tools .
| 1. |
Install the 6 mm (0.236 in) guides from the
EN-46109
pin set into the 2 crankshaft rear oil seal housing corner bolt holes of the engine block.
|
|
| 2. |
Install the
EN-47839
tool with the
EN-42183
handle (1, 2) onto the rear of the crankshaft flange.
|
|
| 3. |
Place a 3 mm (0.118 in) bead of RTV sealant to the NEW crankshaft rear oil seal housing as shown (1). Refer to
Adhesives, Fluids, Lubricants, and Sealers
for the recommended sealant.
|
|
| 4. |
Install the crankshaft rear oil seal housing to the engine block. 
|
|||||||
| 5. |
Remove the
EN-46109
pin set 6 mm (0.236 in) guides from the engine block.
|
|
| 6. |
Install the crankshaft rear oil seal housing bolts.
|
|
| 7. |
Refer to
Fastener Caution
.
Tighten the crankshaft rear oil seal housing bolts in sequence and tighten to 10 Nm (89 lb in) . 
|
|
| 8. |
Remove the
EN-47839
tool and
EN-42183
handle (1, 2) from the crankshaft flange.
|
|
