PRE-RELEASE
DTC P0219 (LLU)
| DTC P0219 (LLU) |
| Diagnostic Instructions |
| • |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
|
| • |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
|
| • |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
|
| DTC Descriptor |
DTC P0219 00
Engine Overspeed
| Circuit/System Description |
| Note | ||
|
This DTC is used for information only. This DTC does NOT indicate there is a condition with the crankshaft position sensor or the engine control module. |
This DTC is used to indicate that the engine speed exceeded the fuel cutoff limit in gear. This DTC may set if the transmission is placed in a low gear while driving down a steep grade or traveling at a high speed.
| Conditions for Running the DTC |
| • |
The engine is running.
|
|
| • |
The DTC runs continuously once the above condition is met.
|
|
| Conditions for Setting the DTC |
The ECM detects the engine speed is greater than 6800 RPM for greater than 0.4 s.
| Action Taken When the DTC Sets |
DTC P0219 00 is a Type D DTC.
| Conditions for Clearing the DTC |
DTC P0219 00 is a Type D DTC.
| Diagnostic Aids |
An overspeed condition can only exist when a low gear on a manual transmission is selected and the vehicle is traveling at high road speed. This DTC cannot be set by free reving the engine.
| Reference Information |
Schematic Reference
Engine Controls Schematics
Connector End View Reference
Component Connector End Views
Electrical Information Reference
| • |
Circuit Testing
|
|
| • |
Connector Repairs
|
|
| • |
Testing for Intermittent Conditions and Poor Connections
|
|
| • |
Wiring Repairs
|
|
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Scan Tool Reference
Control Module References for scan tool information
| Circuit/System Testing |
Observe the DTCs with the scan tool.
| Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
