PRE-RELEASE
DTC P0610 (LLU)
| DTC P0610 (LLU) |
| Diagnostic Instructions |
| • |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
|
| • |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
|
| • |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
|
| DTC Descriptor |
DTC P0610 00
Control Module Vehicle Options Incorrect
| Circuit/System Description |
This diagnostic verifies that the engine control module (ECM) is programmed for the correct vehicle options.
| Conditions for Running the DTC |
| • |
The ignition is ON.
|
|
| • |
The ignition voltage is between 8-16 V
|
|
| Conditions for Setting the DTC |
The ECM detects that programming for vehicle options is incorrect.
| Action Taken When the DTC Sets |
| • |
DTC P0610 00 is a Type C DTC.
|
|
| • |
The service vehicle soon indicator will illuminate.
|
|
| Conditions for Clearing the DTC |
DTC P0610 00 is a Type C DTC.
| Reference Information |
Schematic Reference
Engine Controls Schematics
Connector End View Reference
Component Connector End Views
Electrical Information Reference
| • |
Circuit Testing
|
|
| • |
Connector Repairs
|
|
| • |
Testing for Intermittent Conditions and Poor Connections
|
|
| • |
Wiring Repairs
|
|
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Scan Tool Reference
Control Module References
| Circuit/System Verification |
| 1. |
With the engine running, check the DTC Information with the scan tool. DTC P0610 00 should not be set.
|
|
| 2. |
Operate the vehicle within the conditions for running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the freeze frame/failure records data.
|
|
| Circuit/System Testing |
| 1. |
Program the K20 Engine Control Module. Refer to
Control Module References
.
|
|
| 2. |
Clear DTCs with a scan tool.
|
|
| 3. |
Ignition OFF, allow the K20 Engine Control Module to completely power down.
|
|
| 4. |
Operate the vehicle within the conditions for running DTC P0610 00.
|
|
| 5. |
Verify with a scan tool that DTC P0610 00 has not reset.
|
|
| 6. |
If DTC P0610 00 does reset, replace the K20 Engine Control Module.
|
|
| Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for ECM replacement, setup, and programming
