SAAB WIS ONLINE

PRE-RELEASE

Fuel Feed Pipe Replacement (Metal)

Fuel Feed Pipe Replacement (Metal)



Special Tools

• EN-796-A Remover

• GE-611 Torque Wrench

• GE-6600-207 Installer


For equivalent regional tools, refer to Special Tools .

Removal Procedure


1.
Warning

Relieve the fuel system pressure before servicing fuel system components in order to reduce the risk of fire and personal injury.

After relieving the system pressure, a small amount of fuel may be released when servicing the fuel lines or connections. In order to reduce the chance of personal injury, cover the regulator and the fuel line fittings with a shop towel before disconnecting. This will catch any fuel that may leak out. Place the towel in an approved container when the disconnection is complete.


Relief the fuel pressure. Refer to Fuel Pressure Relief .

2. Remove engine sight shield. Refer to Engine Sight Shield Replacement .

3. Remove the fastener (1) from the fuel pump module (2) with EN-796-A remover.


4. Remove the fuel feed pipe plastic (3) with EN-796-A remover from the fuel feed pipe metal (4).

5. Remove the 2 fasteners (1) and get out the fuel feed pipe metal (2).



Installation Procedure


1. Refer to Fastener Caution .

Install the 2 fasteners (1) to the intake manifold but do not tighten yet.


2. Install the fastener (2) to the fuel pump module and tighten to 30 Nm (22 lb ft) with the fitting tool GE-6600-207 and torque wrench GE-611 .

3. Tighten the 2 fasteners (1) to 7 Nm (62 lb in) .

4. Install the fuel feed pipe plastic to the fuel feed pipe metal.


PRE-RELEASE