PRE-RELEASE
DTC P0315
| DTC P0315 |
| Diagnostic Instructions |
| • |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
|
| • |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
|
| • |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
|
| DTC Descriptor |
DTC P0315: Crankshaft Position System Variation Not Learned
| Circuit/System Description |
The crankshaft position system variation learn feature is used to calculate reference period errors caused by slight tolerance variations in the crankshaft, and the crankshaft position sensor. The calculated error allows the engine control module (ECM) to accurately compensate for reference period variations. This enhances the ability of the ECM to detect misfire events over a wider range of engine speed and load conditions.
The compensation values for the crankshaft position system variation are stored in the ECM memory after a learn procedure has been carried out and the ignition switch has been turned to OFF for at least 30 seconds. If the actual variation does not match the compensation values for the crankshaft system variation stored in the ECM memory, DTC P0300 may be set.
If the crankshaft position system variation values are not stored in the ECM memory or a proper ECM power down does not occur after completing the Crankshaft Position Learn Procedure, DTC P0315 sets.
| Conditions for Running the DTC |
DTC P0315 runs continuously.
| Conditions for Setting the DTC |
The ECM detects that the crankshaft position system variation values are not stored in memory.
| Action Taken When the DTC Sets |
DTC P0315 is a Type A DTC.
| Conditions for Clearing the MIL/DTC |
DTC P0315 is a Type A DTC.
| Diagnostic Aids |
This test procedure requires that the vehicle battery has passed a load test and is completely charged. Refer to Battery Inspection/Test .
| Reference Information |
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Scan Tool Reference
Control Module References for scan tool information
| Circuit/System Testing |
| Note | ||
|
The Crankshaft Position Variation Learn may have to be repeated up to 5 times before the procedure is successful. |
| 1. |
Perform the
Crankshaft Position System Variation Learn
procedure. The scan tool should display Learned Successful.
|
|
| 2. |
If the Crankshaft Position System Variation Learn Procedure cannot be performed successfully, inspect for the following conditions:
|
|
| • |
Worn crankshaft main bearings
|
| • |
A damaged or misaligned reluctor wheel
|
| • |
Excessive crankshaft runout
|
| • |
A damaged crankshaft-Refer to
Crankshaft and Bearing Cleaning and Inspection
.
|
| • |
Interference in the signal circuit of the crankshaft position sensor
|
| • |
The ignition switch is in the ON position until there is insufficient system voltage.
|
| • |
An ECM power disconnect with the ignition ON that may have erased the crankshaft position system variation values and set DTC P0315
|
| • |
Any debris between the crankshaft position sensor and the reluctor wheel
|
| 3. |
Verify the Learn Procedure is successful.
|
|
| 4. |
If the ECM is unable to complete the learn procedure, replace the ECM.
|
|
| Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for ECM replacement, setup, and programming
