PRE-RELEASE
DTC B1016
| DTC B1016 |
| Diagnostic Instructions |
| • |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
|
| • |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
|
| • |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
|
| DTC Descriptor |
DTC B1016 XX
Vehicle Identification Number Information Not Programmed
| Circuit/System Description |
The control module performs a self test and vehicle identification number (VIN) verification. This DTC indicates that a VIN is not programmed or that the control module has an internal fault. The internal fault detection is handled inside the control module, no external circuits are involved.
| Conditions for Running the DTC |
The only requirements are voltage and ground.
| Conditions for Setting the DTC |
The control module has detected that the VIN is not programmed.
| Conditions for Clearing the DTC |
| • |
The condition for setting the DTC is no longer present.
|
|
| • |
The history DTC will clear after 50 fault-free ignition cycles.
|
|
| • |
The DTC can be cleared using a scan tool.
|
|
| Circuit/System Verification |
Verify DTC B1016 is not set.
| Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for control module replacement, setup, and programming
