SAAB WIS ONLINE

PRE-RELEASE

DTC U0300-U0336

DTC U0300-U0336

Diagnostic Instructions


Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

Review Strategy Based Diagnosis for an overview of the diagnostic approach.

Diagnostic Procedure Instructions provides an overview of each diagnostic category.


DTC Descriptors

DTC U0301 00

Software Incompatibility With Engine Control Module

DTC U0302 00

Software Incompatibility with Transmission Control Module

DTC U0315 00

Software Incompatibility with Electronic Brake Control Module

Circuit/System Description

Some control modules must be configured with specific software, serial numbers, vehicle options, or other information. If a control module was not properly configured after installation that module may set the appropriate U Code. No external circuit diagnosis is involved.

Conditions for Running the DTC

Battery voltage is between 9-16 V and data link communications operate normally.

Conditions for Setting the DTC

The control module is not configured properly.

Conditions for Clearing the DTC


A current DTC clears when the malfunction is no longer present.

A history DTC clears when the module ignition cycle counter reaches the reset threshold, without a repeat of the malfunction.


Reference Information

Schematic Reference

Data Communication Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Data Link Communications Description and Operation

Electrical Information Reference


Circuit Testing

Connector Repairs

Testing for Intermittent Conditions and Poor Connections

Wiring Repairs


Scan Tool References

Control Module References for scan tool information

Circuit/System Verification

Verify the appropriate DTC is not set.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for control module replacement, setup, and programming

PRE-RELEASE