PRE-RELEASE
Generator Noise Diagnosis
| Generator Noise Diagnosis |
| Diagnostic Instructions |
| • |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
|
| • |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
|
| • |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
|
| Diagnostic Aids |
Noise from a generator may be due to electrical or mechanical noise. Electrical noise or magnetic whine usually varies with the electrical load placed on the generator and is a normal operating characteristic of all generators. When diagnosing a noisy generator, it is important to remember that loose or misaligned components around the generator may transmit the noise into the passenger compartment and that replacing the generator may not solve the problem.
| Circuit/System Testing |
| 1. |
Start the engine. Verify the noise can be heard. Compare the concern to a similar vehicle.
|
|
| 2. |
Perform a charging system test. Verify that the generator is charging properly. Refer to
Charging System Test
.
|
|
| 3. |
Inspect the G13 generator, generator mounting, wiring harness, heater hoses, A/C lines, or other accessory equipment that may be misrouted or be the cause of noise being transmitted into the passenger compartment.
|
|
| 4. |
Ignition OFF, remove the engine drive belt. Verify the generator, A/C compressor, water pump pulley, power steering pump, idler pulley, and tensioner pulley spin freely.
|
|
| 5. |
If any of the pulleys do not spin freely, replace the affected component.
|
|
| 6. |
Start the engine, with the drive belt removed. Verify that the noise goes away. Operate the engine for no longer than 30-40 seconds.
|
|
| 7. |
If the noise is still present, the generator is not the cause of the noise.
|
|
| 8. |
Loosen all generator mounting bolts and ensure the generator is properly aligned. Tighten the mounting bolts to specification, refer to
Generator Replacement (Diesel)
Generator Replacement (LAU/A28NER)
Generator Replacement (LLU/A16LET)
Generator Replacement (LHU/A20NFT)
.
|
|
| Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • |
Drive Belt Replacement
for 2.0L
|
|
| • |
Drive Belt Tensioner Replacement
for 2.0L
|
|
| • |
Drive Belt Replacement
for 2.0L Diesel
|
|
| • |
Drive Belt Tensioner Replacement
for 2.0L Diesel
|
|
| • |
Drive Belt Replacement
for 2.8, 3.0, 3.2 and 3.6L
|
|
| • |
Drive Belt Tensioner Replacement
for 2.8, 3.0, 3.2 and 3.6L
|
|
| • |
Refer to
Generator Replacement (Diesel)
Generator Replacement (LAU/A28NER)
Generator Replacement (LLU/A16LET)
Generator Replacement (LHU/A20NFT)
.
|
|
