Front Brake Caliper Replacement (J64)
|
|
Front Brake Caliper Replacement (J64)
|
|
Callout
|
Component Name
|
Refer to
Brake Dust Warning
.
Refer to
Brake Fluid Irritant Warning
.
Preliminary Procedure
|
1
|
Brake Hose-To-Caliper Bolt
Refer to
Fastener Caution
.
Warning
|
|
Do not depress the brake pedal with the brake rotors and/or the brake drums removed, or with the brake calipers repositioned away from the brake rotors, or damage to the brake system may result.
|
|
|
|
|
|
Procedure
Plug the brake hose fitting to prevent brake fluid loss and contamination.
Tighten
40 Nm (30 lb ft)
|
2
|
Brake Hose Fitting Gasket (Qty: 2)
Procedure
Discard the old gaskets and replace with NEW gaskets during installation.
|
3
|
Front Brake Caliper Fastener (Qty: 2)
Procedure
Install NEW bolts.
Tighten
150 Nm (111 lb ft) + 45 degrees + 15 degrees
|
4
|
Front Brake Caliper
|
Warning
|
|
At times during this brake bleed procedure brake fluid will be under higher pressures than during typical brake bleed procedures. Ensure the bleeder hose attached to the bleeder valve is securely maintained in position whenever the bleeder valve is opened. Failure to maintain the bleeder hose securely to the valve when opened, may allow the hose to blow off and brake fluid to spray out of the bleeder valve, possibly resulting in personal injury.
|
|
|
|
|
|
|
Warning
|
|
Remove all the air from the hydraulic brake system anytime the hydraulic brake system is opened for repair. The entire bleeding procedure must be followed. Failure to remove all the air in the hydraulic brake system will result in reduced braking performance and possible personal injury.
|
|
|
|
|
|
Procedure
Bleed the hydraulic brake system. Refer to
Hydraulic Brake System Bleeding
.
|
