Rear Disc Brake Pads Replacement (J60)
|
|
Rear Disc Brake Pads Replacement (J60)
|
|
Callout
|
Component Name
|
Refer to
Brake Dust Warning
.
Refer to
Brake Fluid Irritant Warning
.
Refer to
Brake Fluid Effects on Paint and Electrical Components Caution
.
Preliminary Procedure
|
1.
|
Inspect the fluid level in the brake master cylinder reservoir
|
|
|
•
|
If the brake fluid level is midway between the maximum-full point and the minimum allowable level then no brake fluid needs to be removed from the reservoir before proceeding.
|
|
|
•
|
If the brake fluid level is higher than midway between the maximum-full point and the minimum allowable level then remove brake fluid to the midway point before proceeding.
|
|
1
|
Guide Pin Bolt (Qty: 2)
Refer to
Fastener Caution
.
Tighten
32 Nm (24 lb ft)
|
2
|
Brake Caliper
Warning
|
|
Suspend the brake caliper with a strong steel wire or similar. This applies every time the caliper is removed from its mounting with the brake hose is still attached. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which may cause damage to the brake hose and in turn may cause a brake fluid leak.
|
|
|
|
|
|
Procedure
Secure with heavy mechanics wire or equivalent.
|
3
|
Rear Disc Brake Pads
Procedure
|
1.
|
Use one or two wheel lugs nuts to hold the brake rotor in place while servicing the brake pads.
|
|
2.
|
If removing the brake pads to service the brake system, mark the inner and outer pads for the proper installation.
|
|
3.
|
Use
CH-6007-B
resetting tool in order to twist the brake caliper piston into the brake caliper bore.
|
|
4.
|
If installing new brake pads, discard the spring clips. Install NEW spring clips.
|
|
5.
|
With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
|
|
6.
|
Slowly release the brake pedal.
|
|
7.
|
Wait 15 seconds, then repeat steps 5-6 until a firm brake pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
|
|
8.
|
Fill the master cylinder reservoir to the proper level.
|
Special Tools
CH-6007-B
Resetting Tool
For equivalent regional tools, refer to
Special Tools
.
|
