PRE-RELEASE

Electronic Parking Brake Control Module Replacement

/ 9-5 (9650) / 2011 / 5. Brakes / Handbrake / Adjustment/replacement / Electronic Parking Brake Control Module Replacement

Callout

Component Name

Release the electric parking brake using electrical release:

1.1.

Set ignition in Run mode and put your foot on top of the service brake.

1.2.

Press the parking brake switch down and hold for 5 seconds, then a solid yellow telltale is shown on instrument panel.

1.3.

Press the parking brake switch again within 5 seconds, then a flashing yellow telltale is shown on instrument panel.

Release the electric parking brake using manual release:

2.1.

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .

2.2.

Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation

2.3.

Remove the rear wheelhouse panel liner. Refer to Rear Wheelhouse Panel Liner Replacement .

2.4.

Remove the rubber plug. (Arrow)

2.5.

Using a square tool with measure 3,2 mm (1/8") release the tension of the cable.

Electronic Parking Brake Control Module Cable

Electronic Parking Brake Control Module Clip (Qty: 2)

Electronic Parking Brake Control Module Nut (Qty: 3)

Refer to Fastener Caution .

9.5 Nm (84 lb in)

Electronic Parking Brake Control Module

Program the electronic parking brake control module. Refer to Electronic Parking Brake Control Module Programming and Setup .