SAAB WIS ONLINE

PRE-RELEASE

Parking Brake Rear Cable Replacement (J71)

Parking Brake Rear Cable Replacement (J71)



Callout Component Name

Preliminary Procedure

1. Release the electric parking brake.

1.1. Set ignition in Run mode and put your foot on top of the service brake.

1.2. Press the parking brake switch down and hold for 5 seconds, then a solid yellow telltale is shown on instrument panel.

1.3. Press the parking brake switch again within 5 seconds, then a flashing yellow telltale is shown on instrument panel.

2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .

3. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .

4. Remove the rear wheelhouse panel liner. Refer to Rear Wheelhouse Panel Liner Replacement .


1

Electric Park Brake Module Cable

Refer to Fastener Caution .

Tighten

6 Nm (53 lb in)

2

Retainer Washer

3

Parking Brake Cable

4

Protector Parking Brake Cable

5

Retainer Washer (Qty: 2)

6

Parking Brake Rear Cable



PRE-RELEASE