SAAB WIS ONLINE

PRE-RELEASE

DTC C0574

DTC C0574

Diagnostic Instructions


Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

Review Strategy Based Diagnosis for an overview of the diagnostic approach.

Diagnostic Procedure Instructions provides an overview of each diagnostic category.


DTC Descriptors

DTC C0574 01

Circuit Board Temperature Sensor Short to Battery

DTC C0574 02

Circuit Board Temperature Sensor Short to Ground

DTC C0574 54

Circuit Board Temperature Sensor High

Circuit/System Description

The parking brake control module has an internal motor, apply actuator, release actuator, and temperature sensor. The parking brake control module also contains the logic for applying and releasing the park brake when commanded by the park brake control switch. When the parking brake control module receives a signal from the switch the internal circuit board temperature is checked to verify it is within operating range before the control module performs the requested operation.

Conditions for Running the DTC

Ignition OFF, ACCESSORY, or RUN mode.

Conditions for Setting the DTC

C0574 01, C0574 02

The parking brake control module detects a short to battery or a short to ground.

C0574 54

The parking brake control module has detected an internal temperature that is above the allowed value.

Action Taken When the DTC Sets


A message and/or a warning indicator may be displayed.

The electric parking brake is disabled, one release allowed.


Conditions for Clearing the DTC


The parking brake control module clears the history DTC when a current DTC is not detected in 40 ignition cycles.

The parking brake control module is replaced or the internal temperature drops below the allowed temperature.


Diagnostic Aids

Check for debris on the parking brake control module which may cause the module to overheat.

Reference Information

Schematic Reference

Park Brake System Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Electronic Parking Brake Control Module Description

Electrical Information Reference


Circuit Testing

Connector Repairs

Testing for Intermittent Conditions and Poor Connections

Wiring Repairs


Scan Tool Reference

Control Module References for scan tool information

Circuit/System Verification

C0574 01 or C0574 02

Remove the EPB fuse and reinstall. Verify DTC C0574 is not set.


C0574 54

1.
Note

Diagnose all other parking brake control module system related faults before performing this diagnostic. Other faults may cause the circuit board to overheat. Do not attempt to apply the electric parking brake.


Allow the parking brake control module to cool down for 15 minutes.

2. Verify DTC C0574 54 is not set.

3. If DTC is set, replace the K83 Parking Brake Control Module.


Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for parking brake control module replacement, setup, and programming

PRE-RELEASE