PRE-RELEASE
DTC C0569
| DTC C0569 |
| Diagnostic Instructions |
| • |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
|
| • |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
|
| • |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
|
| DTC Descriptor |
DTC C0569 00
System Configuration Malfunction
| Circuit/System Description |
The electronic brake control module (EBCM) receives controller area network (CAN) serial data messages from other modules. The EBCM must be configured with the vehicle identification number (VIN), CAN configuration data and vehicle options. If not properly configured after installation, the EBCM may set a DTC.
The internal fault detection is handled inside the control module. No external circuits are involved.
| Conditions for Running the DTC |
Ignition ON
| Conditions for Setting the DTC |
A mandatory control module is not programmed to the EBCM CAN configuration list.
| Action Taken When the DTC Sets |
| • |
The EBCM disables the traction control, stability control and hill start assist for the duration of the ignition cycle.
|
|
| • |
The traction control/stability control-active indicator turns ON.
|
|
| Conditions for Clearing the DTC |
A current DTC clears when the diagnostic runs and passes.
| Diagnostic Aids |
A newly replaced EBCM can set one or more DTC on its initial ignition ON cycle.
| Reference Information |
Schematic Reference
Antilock Brake System Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
ABS Description and Operation
Electrical Information Reference
| • |
Circuit Testing
|
|
| • |
Connector Repairs
|
|
| • |
Testing for Intermittent Conditions and Poor Connections
|
|
| • |
Wiring Repairs
|
|
Scan Tool Reference
Control Module References for scan tool information
| Circuit/System Testing |
| 1. |
Verify that DTC C0569 00 is not present.
|
|
| 2. |
If DTC C0569 00 is present, program the K17 Electronic Brake Control Module and verify the DTC does not reset.
|
|
| 3. |
If the DTC resets, replace the K17 Electronic Brake Control Module.
|
|
| Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for EBCM replacement, setup and programming
