SAAB WIS ONLINE

PRE-RELEASE

Power Steering Pressure Pipe/Hose Replacement (V6)

Power Steering Pressure Pipe/Hose Replacement (V6)



Callout Component Name

Preliminary Procedure

1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .

2. Place drain pans under the vehicle.

3. Remove as much power steering fluid from the remote power steering fluid reservoir as possible.

4. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .

5. Remove the front fascia. Refer to Front Bumper Fascia Replacement .


1

Power Steering Pressure Pipe/Hose Retainer

Procedure

Install a NEW power steering gear inlet hose O-ring seal and moisture with steering gear fluid, prior to installation of the hose.

2

Power Steering Pressure Pipe/Hose Clip (Qty: 4)

3

Power Steering Pressure Pipe/Hose Bracket Bolt

Refer to Fastener Caution .

Tighten

9 Nm (80 lb in)

4

Power Steering Pressure Pipe/Hose


Procedure

1. Install NEW steering gear oil seals and moisture with steering gear fluid.

2. Fill and bleed the power steering system. Refer to Power Steering System Bleeding .

3. Clean any excess power steering fluid from the vehicle.




PRE-RELEASE