PRE-RELEASE
Sunroof Housing Replacement
| Sunroof Housing Replacement |
| Removal Procedure |
| 1. |
It is only necessary to lower the headliner. Only perform the steps in the headliner replacement procedure that will lower the headliner enough to gain access to the part. Refer to
Headlining Trim Panel Replacement (Without Sunroof)
Headlining Trim Panel Replacement (With Sunroof)
.
|
|
| 2. |
Remove the front water drain hose from the housing connector.
Remove the 2 hoses. 
|
|
| 3. |
Remove the rear water drain hose from the housing connector.
Remove the 2 hoses. 
|
|
| 4. |
Disconnect the front wiring harness actuation unit.
Disconnect the 2 wiring harness plugs. |
|
| 5. |
Remove the sunroof housing fasteners.
|
|
| 6. |
Remove the Sunroof Housing Assembly.
|
|
| Installation Procedure |
| 1. |
Transfers all parts as necessary.
|
|
| 2. |
Refer to
Fastener Caution
Insert the sunroof housing assembly to gauge pin location in the opening. Thight the three fasteners. |
|
| 3. |
Install the sunroof housing assembly with the remaining fasteners and tighten to
9 Nm (80 lb in)
.
|
|
| 4. |
Connect the front wiring harness actuation unit.
Connect the 2 wiring harness plugs. |
|
| 5. |
Install the rear water drain hose actuation unit.
Connect the 2 hoses and apply tie straps if required. |
|
| 6. |
Install the front water drain hose actuation unit.
Connect the 2 hoses and apply tie straps if required. |
|
| 7. |
Verify the operation of the sunroof.
|
|
| 8. |
Water test the vehicle before installing the headliner.
|
|
| 9. |
Install the headlining. Refer to
Headlining Trim Panel Replacement (Without Sunroof)
Headlining Trim Panel Replacement (With Sunroof)
.
|
|
