Sunroof Motor/Actuator Initialization/Teach Process (New motor)
|
|
Sunroof Motor/Actuator Initialization/Teach Process (New motor)
|
Perform the Initialization/Teach Process any time the sunroof motor/actuator is removed from the sunroof.
"Manual" indicates the first switch detent
"Express" indicates the second switch detent
|
1.
|
Ensure that the electrical harness is connected to the sunroof motor.
|
|
2.
|
Make sure the glass/roller blind is in the full close position before re-initialization.
|
|
3.
|
Re-initialization (Normalization) - Press "manual close switch" for more than 10 seconds until glass/roller blind finds hard stop.
|
|
4.
|
Learn (this step is recommended for existing motors but required for new motors):
|
|
|
4.1.
|
Open the glass/roller blind with the express or manual open switch to the full open position and release the switch
|
|
|
4.2.
|
Press "manual open switch" for more than 10 seconds until the sunroof glass/roller blind starts AND reaches the Closed Position.
|
|
5.
|
Verify the operation of the sunroof.
|
|
Note
|
|
The Initialization/Teach Process is not complete if any of the following actions take place before the initialization cycle is done:
|
|
•
|
The sunroof switch is not held in the close position.
|
|
•
|
The ignition and/or battery power has been removed.
|
|
•
|
The glass panel has not reached the closed position.
|
|
The Initialization/Teach Process must be restarted if the procedure is not carried out completely.
|
