Crankshaft position sensor
|
|
Crankshaft position sensor
|
The crankshaft position sensor is mounted on the crankshaft at the flywheel end
of the engine block.
|
1.
|
Take off the engine
cover.
|
|
2.
|
Remove the turbo pressure pipe and plug the turbo's delivery
hose.
|
|
3.
|
Release the sensor wiring by unplugging the connector and removing the
clips/cable ties.
|
Important
|
|
Note how the wiring is run.
|
|
|
|
|
5.
|
Remove the sensor retaining bolt and remove the sensor. Note how the sealing
ring is fitted.
|
|
1.
|
Clean the sensor seating and fit
the sensor with the sealing ring correctly mounted.
Tightening torque, retaining bolt: 8 Nm (5.9 lbf
ft)
|
|
2.
|
Refit the wiring and secure it with clips/cable ties.
|
|
3.
|
Plug in the connector.
|
|
4.
|
Refit the turbo's pressure pipe and engine cover.
|
