PRE-RELEASE
Throttle body
| Throttle body |
| To remove |
| 1. |
Take off the engine
cover.
|
|
| 2. |
Remove the connecting pipe from the throttle body.
|
|
| 3. |
Disconnect the throttle cable and Cruise Control cable.
|
|
| 4. |
Unscrew the expansion tank filler cap to release the pressure in the cooling
system.
|
|
| 5. |
Remove the idle air control valve.
|
|
| 6. |
Disconnect the coolant hoses from the throttle body.
|
|
| 7. |
Disconnect other hoses from the throttle body.
|
|
| 8. |
Remove the throttle position sensor.
|
|
| 9. |
Remove the 4 retaining screws and lift away the throttle body.
|
|
| To fit |
| 1. |
Check the condition and
positioning of the O-ring.
|
|
| 2. |
Fit the throttle body and tighten the retaining screws.
Tightening torque 8 Nm (6lbf ft) |
|
| 3. |
Fit the throttle position sensor.
|
|
| 4. |
Check the setting of the throttle valve by measuring the depth to the valve. The
distance should be the same on both sides of the throttle valve. Use a slide caliper. If
necessary, adjustment can be carried out by undoing the 2 screws and then moving the
bracket in the desired direction.
|
|
| 5. |
Connect all hoses as well as the throttle cable and Cruise Control cable.
|
|
| 6. |
Fit the idle air control valve.
|
|
| 7. |
Fit the connecting pipe to the throttle body.
|
|
| 8. |
Fit the cover in place.
|
|
| 9. |
Check the function
|
|
