PRE-RELEASE
Sunroof drive cable
| Sunroof drive cable |
| To remove |
| 1. |
Remove the sunroof
assembly.
|
|
| 2. |
Remove the motor.
|
|
| 3. |
Remove the glass sunroof.
|
|
| 4. |
Remove the rain gutter.
|
|
| 5. |
Remove the locking ring and bend out the spring.
|
|
| 6. |
Remove the screw securing the cover at the rear, one cover strip on each
side.
|
|
| 7. |
Move the rain gutter holders downwards towards the rear and withdraw
them from the rail, one on each side.
|
|||||||
| 8. |
Press down the catch at the rear of the slide mechanism and pull it
rearwards.
|
|
| 9. |
Withdraw the cable to the rear.
|
|
| 10. |
Disconnect the cable from the slide mechanism, using a small
screwdriver (snap-on fastener).
|
|
| To fit |
| 1. |
Attach the cable to the slide
mechanism.
|
|
| 2. |
Insert the slide mechanism with cable until it snaps into place.
|
|
| 3. |
Fit the rain gutter holders.
|
|
| 4. |
Fit the anti-vibration spring and locking ring.
|
|
| 5. |
Apply a little adhesive to the rear edge of the covers.
|
|
| 6. |
Fit the rain gutter.
|
|
| 7. |
Adjust the cables on both sides. Check that the rivet is midway between
the two marks on the link.
|
|
| 8. |
Fit the motor.
|
|
| 9. |
Fit the glass sunroof.
|
|
| 10. |
Fit the sunroof
assembly.
|
|
