Replacement of handbrake cable (2-cable)
|
|
Replacement of handbrake cable (2-cable)
|
|
1.
|
Lift the car and remove the rear
wheels.
|
|
2.
|
Remove the two left-hand fixing nuts from the centre heat shield.
|
|
3.
|
Remove the three securing bolts from the rear heat shield.
|
|
4.
|
Measure the length of the protruding part of the pull rod from the adjusting nut to
the end.
|
|
5.
|
Remove the adjusting nut.
|
|
6.
|
Undo the left-hand tank strap.
|
|
7.
|
Unhook the bracket from the tank strap.
|
|
8.
|
Remove the spring from the lever.
|
|
9.
|
Undo the back cable guide sleeve and disconnect the cables from the
levers.
|
|
10.
|
Pull the wires out of the holes on the rear axle.
|
|
11.
|
Loosen the right-hand from the bracket under the rear heat
shield.
|
|
12.
|
Remove the cables from the bracket behind the cable adjuster.
|
|
13.
|
Cut off the tie that holds the cable under the heat shield.
|
|
1.
|
Position the cables, pull
forwards and connect them to the forward holder.
|
|
2.
|
Fasten a new tie to the cables under the heat shield.
|
|
3.
|
Fit the cables to the rear guide sleeves and the levers.
|
|
4.
|
Fit the springs to the levers.
|
|
5.
|
Fit the pull rod adjustment nut to the previously measured thread
length.
|
|
6.
|
Pull the tank strap tight.
|
|
7.
|
Lift the car and tighten the pull rod adjusting nut until the brakes start to
act.
|
|
8.
|
Lower the car, release the handbrake and then operate it again. The wheels
should lock at the 6th notch.
|
|
9.
|
Lift the car and fasten the centre heat shield.
|
|
10.
|
Fasten the rear heat shield.
|
|
11.
|
Fit the back wheels and tighten the wheel studs.
Tightening torque, light alloy wheels 117 Nm (86.6 lbf ft)
Tightening torque, pressed steel wheels 100 Nm (74 lbf
ft)
|
