PRE-RELEASE
INSTALLATION
| INSTALLATION |
Install the front oxygen (A/F) sensor and the rear oxygen sensor.
.
Install the front exhaust pipe to center exhaust pipe.
| Note | ||
|
Replace the gaskets with new ones. |
Tightening torque:
30 Nm (3.1 kgf-m, 22.4 ft-lb)
Temporarily tighten the bolt which installs the front and center exhaust pipe assembly to hanger bracket.
Tighten the nuts which hold the front exhaust pipe onto cylinder heads.
Tightening torque:
30 Nm (3.1 kgf-m, 22.4 ft-lb)
Install the under cover.
Tighten the bolts which install the front and center exhaust pipe assembly to rear exhaust pipe.
Tightening torque:
18 Nm (1.8 kgf-m, 13.0 ft-lb)
Tighten the bolt which holds the front and center exhaust pipe assembly to hanger bracket.
Tightening torque:
35 Nm (3.6 kgf-m, 26.0 ft-lb)
Lower the vehicle.
Connect the rear oxygen sensor connector.
Connect the front oxygen (A/F) sensor connector.
Connect the battery ground cable to battery.
