PRE-RELEASE
DTC 11, 15, 21 AND 24 CRUISE CONTROL COMMAND SWITCH
| DTC 11, 15, 21 AND 24 CRUISE CONTROL COMMAND SWITCH |
TROUBLE SYMPTOM:
| • |
Cruise
control cannot be set. (Cancelled immediately.)
|
|
| • |
Cruise control cannot be released.
|
|
WIRING DIAGRAM:
CHECK CRUISE SWITCH CIRCUIT.
Turn the ignition switch to OFF.Disconnect the ECM harness connector.
Turn the ignition switch to ON.
Measure the voltage between harness connector terminal and chassis ground when the cruise control main switch is pressed and is not pressed.
Connector & terminal
(B136) No. 7 (+) — Chassis ground (−):
Is the voltage 0 V when the cruise control main switch is not pressed? Is the voltage more than 10 V when the cruise control main switch is pressed?
| Yes |
| No |
| • |
Check the fuse No. 18 (in fuse & relay box).
|
|
| • |
Check the harness for open or short between cruise control command
switch and fuse & relay box. If no malfunction is found
after checking above,
|
|
CHECK SET/COAST SWITCH CIRCUIT.
Turn the ignition switch to OFF.Disconnect the ECM harness connector.
Measure the voltage between harness connector terminal and chassis ground when SET/COAST switch is pressed and not pressed.
Connector & terminal
(B136) No. 11 (+) — Chassis ground (−):
Is the voltage 0 V when SET/COAST switch is not pressed? Is the voltage more than 10 V when SET/COAST switch is pressed?
| Yes |
| No |
CHECK RES/ACC SWITCH CIRCUIT.
Measure the voltage between harness connector terminal and chassis ground when RES/ACC switch is pressed and not pressed.Connector & terminal
(B136) No. 1 (+) — Chassis ground (−):
Is the voltage 0 V when RES/ACC switch is not pressed? Is the voltage more than 10 V when RES/ACC switch is pressed?
| Yes |
| No |
CHECK CANCEL SWITCH CIRCUIT.
Measure the voltage between harness connector terminal and chassis ground when CANCEL switch is pressed and not pressed.Connector & terminal
(B136) No. 1 (+) — Chassis ground (−):
(B136) No. 11 (+) — Chassis ground (−):
Is the voltage 0 V when CANCEL switch is not pressed? Is the voltage more than 10 V when CANCEL switch is pressed?
| Yes |
Cruise control command switch circuit is OK.
| No |
CHECK POWER SUPPLY FOR CRUISE CONTROL COMMAND SWITCH.
Check the horn operation.Does the horn sound?
| Yes |
| No |
| • |
Check the fuse No. 6 (in main fuse box).
|
|
| • |
Check the horn relay.
|
|
| • |
Check the harness for open or short between cruise control command
switch and fuse & relay box.
|
|
CHECK CRUISE CONTROL COMMAND SWITCH.
Remove and check the cruise control command switch.
Is the cruise control command switch OK?
| Yes |
Check the harness between cruise control command switch and ECM.
| No |
Replace the cruise control command switch.
