PRE-RELEASE
INSPECTION
| INSPECTION |
| ABS WHEEL SPEED SENSOR |
Check the pole piece of ABS wheel speed sensor for foreign particles or damage. If necessary, clean the pole piece or replace ABS wheel speed sensor.
Measure the ABS wheel speed sensor resistance.
If resistance is out of standard value, replace the ABS wheel speed sensor with a new one.
| Terminal No. | Standard |
|
1
and 2
|
1.15±0.115
kΩ
|
| Note | ||
|
Check the ABS wheel speed sensor cable for discontinuity. If necessary, replace with a new one. |
| SENSOR GAP |
Measure the clearance between tone wheel and ABS wheel speed sensor at whole periphery.
| Note | ||
|
If clearance is narrow, adjust by using spacer (Part No. 32009555). |
||
|
If clearance is wide, check the outputted voltage then replace the ABS wheel speed sensor or tone wheel if the outputted voltage is outside specification. |
ABS wheel speed sensor clearance:
0.7 — 1.2 mm (0.028 — 0.047 in)
|
(1)
|
Tone wheel
|
|
(2)
|
ABS wheel
speed sensor
|
|
(3)
|
Sensor
gap
|
| OUTPUT VOLTAGE |
Output voltage can be checked by the following method. Install the resistor and condenser, then rotate the wheel about 2.75 km/h (2 MPH) or equivalent.
Output voltage specification:
0.12 — 1 V (at 20 Hz)
| Note | ||
|
Regarding terminal No., please refer
to item 1. ABS WHEEL SPEED SENSOR.
|
|
(1)
|
Oscilloscope
|
|
(2)
|
Terminal
|
