PRE-RELEASE
INSTALLATION
| INSTALLATION |
| Important | ||
|
Be sure the lining surface is free from oil and grease contamination. |
||
Apply brake grease to the following places.
Brake grease:
Brake Grease (Part No. 32005008)
| • |
Six contact
surfaces of shoe rim and back plate packing
|
|
| • |
Contact surface of shoe wave and anchor pin
|
|
| • |
Contact surface of lever and strut
|
|
| • |
Contact surface of shoe wave and adjuster assembly
|
|
| • |
Contact surface of shoe wave and strut
|
|
| • |
Contact surface of lever and shoe wave
|
|
Insert the primary side brake shoe into anchor pin groove.
Secure the brake shoe with shoe hold-down pin and cup.
Install the plate to anchor pin, and then assemble the primary return spring to anchor pin.
|
(1)
|
Primary
return spring
|
|
(2)
|
Anchor
pin
|
|
(3)
|
Plate
|
|
(4)
|
Primary
shoe
|
|
(5)
|
Shoe hold-down
pin & cup
|
Install the parking brake cable to parking brake lever.
Assemble the strut and adjuster, and then secure the secondary side brake shoe with shoe hold-down pin & cup.
| Note | ||
| • |
Install the strut spring of both right and left wheels
facing vehicle front.
|
|
| • |
Install the adjuster assembly with screw on left side.
|
|
|
(1)
|
Left
|
Install the secondary return spring and adjusting spring.
|
(1)
|
Lever
|
|
(2)
|
Secondary
brake shoe
|
|
(3)
|
Strut spring
|
|
(4)
|
Strut
|
|
(5)
|
Return
spring
|
|
(6)
|
Adjuster
|
|
(7)
|
Shoe hold-down
cup
|
|
(8)
|
Adjusting
spring
|
Adjust the parking brakes.
Drive the vehicle for parking brake lining “break-in”.
Drive the vehicle at about 35 km/h (22 MPH).
With the parking brake release button pushed in, pull the parking brake lever gently.
Drive the vehicle for about 200 meter (0.12 mile) in this condition.
Wait 5 to 10 minutes for the parking brake to cool down. Repeat this procedure once more.
After breaking-in, re-adjust the parking brakes.
