PRE-RELEASE
Selector lever cable
| Selector lever cable |
| 1. |
Remove the battery cover and the battery.
|
|
| 2. |
Remove the rim.
Remove the centre and floor consoles, see service category 8:2 interior equipment
|
|
| 3. |
Detach the air duct to the rear air vent.
|
|
| 4. |
Remove the E-circlip and anti-rattle clip.
|
|
| 5. |
Drive out the pin while removing the end of the cable from the ball.
|
|
| 6. |
Remove the clamp located on the locking catches.
|
|
| 7. |
Carefully press the catches securing the cable ferrule towards each other and remove the cable from the bracket.
|
|
| 8. |
Remove the bracket for the A/C and servo pipes.
|
|
| 9. |
Remove the nut for the lever and lift the lever off the gearbox.
|
|
| 10. |
Remove the clamp at the cable bracket.
|
|
| 11. |
Remove the cable ferrule from the bracket on the gearbox.
|
|
| 12. |
Remove the rubber grommet by first pressing it into the car and then pulling it diagonally through the hole.
|
|
| 13. |
Pull out the whole cable through the engine bay.
|
|
| To fit |
| 1. |
Fit the cable from the engine bay. Make sure it is positioned correctly in the gear-lever housing and press in the rubber grommet.
|
|
| 2. |
Connect the cable to the gear-lever housing and fit the clamp.
|
|
| 3. |
Tap in the pin at the same time as the ball enters the end of the cable.
|
|
| 4. |
Fit the E-circlip and the anti-rattle clip.
|
|
| 5. |
Refit the air duct to the rear air vent.
|
|
| 6. |
Fit the centre and floor consoles, see service category 8:2 Interior equipment
.
Fit the rim. |
|
| 7. |
Attach the selector cable to its mounting and fit the clamp.
|
|
| 8. |
Fit the lever to the gear selector.
|
|
| 9. |
Fit the bracket for the A/C and servo pipes.
|
|
| 10. |
Adjust the position of the cable, see
.
|
|
| 11. |
Fit the battery and battery cover.
|
|
