SAAB WIS ONLINE

PRE-RELEASE

Shift-lock electromagnet

Shift-lock electromagnet

To remove



1. Remove the selector lever housing, see .

Important

When working on a dismantled selector lever housing, the selector lever should be protected with foam rubber or the like.


2. Cut the cable ties.

3. Remove the pins for the electromagnet from the connector, pins 5 and 6 in the 6-pin connector and pin 2 in the 2-pin connector.

Note

Note the location of the 3 pins in the connector.


4. Drill out the rivets, using a three-millimetre bit.

5. Separate the upper and lower parts of the selector lever housing slightly at the front and undo the screws on the electromagnet.


6. Undo the lever on top of the electromagnet and remove the electromagnet.


To fit



1. Fit the electromagnet to the lever.

2. Fit the electromagnet's two screws.

3. Fit the two parts of the selector lever housing together.


4. Rivet the parts of the selector lever housing together.

5. Connect the leads on the electromagnet.

6. Secure the leads with a cable tie.

7. Fit the selector lever housing, see .


PRE-RELEASE