PRE-RELEASE

Gear wheel, removal and fitting

To remove

Note

The gearbox remains in place.

1.	Remove the reversing light switch (2).

2.	Remove the bearing housing cover gasket (3) - see Bearing housing cover gasket, replacement F17 .

3.	Remove the main shaft - see Bearing housing, dismantling and assembling, F 17 .

4.	Dismantle the main shaft. See Main shaft, dismantling and assembly, F17 .

5.	Check the pertinent gear wheels, replace as necessary.

To fit

1.	Assemble the main shaft. See Main shaft, dismantling and assembly, F 17 . Note The 5th gear pinion and gearwheel are removed and fitted as described in service procedure Bearing housing, dismantling and assembling, F17 .

2.	Fit the main shaft - see Bearing housing, dismantling and assembling, F17 .

3.	Fit the bearing housing cover (2). See Bearing housing cover gasket, replacement F17 .

4.	Re-fit the reversing light switch (4) to the gearbox with a new sealing ring. Tightening torque 20 Nm.

5.	Check the gearbox oil level. See Gearbox oil level, checking and correcting F17 .

PRE-RELEASE

This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.

Our Friends