PRE-RELEASE
Centre sill, CV
| Centre sill, CV |
| 1. |
Position the car in an aligning bench and cross-measure if necessary.
|
|
| 2. |
Remove
Front wing
,
Door
,
Outer front sill
and
Side panel, assembly, CV
.
|
|
| 3. |
Drill out the spot welds.
|
|
| 4. |
Drill out the spot welds (rear welds at the wheel housing).
|
|
| 5. |
Tap loose the centre sill. In order to access the upper section the overhead panel must be bent up slightly.
|
|
| 6. |
Straighten any distorted panel. Grind all surfaces to be welded.
|
|
| 7. |
Drill holes for plug-welding in the spare part.
|
|
| 8. |
Apply welding primer to the surfaces to be spot and plug welded. Use Teroson Zink Spray.
|
|
| 9. |
Place the centre sill in fitting position and secure it with several welding clamps.
|
|
| 10. |
Spot and plug weld the centre sill.
|
|
| 11. |
Smooth off the welds.
|
|
| 12. |
Wash away surplus welding primer. Welding primer reduces the adhesion of paint, filler and sealant.
|
|
| 13. |
Apply primer to all bare metal surfaces. Use Standox 1K.
|
|
| 14. |
Seal joints and seams with sealant. Use 1K-PUR.
|
|
| 15. |
Apply anti-corrosion agent to internal surfaces after painting. Use Terotex HV 400.
|
|
| 16. |
Fit
Side panel, assembly, CV
,
Outer front sill, CV
,
Front wing
and
Door
.
|
|
