PRE-RELEASE

Rear crankshaft seal

To remove

1.	Remove the gearbox. See Manual gearbox assembly, Z19DT/DTH , Automatic transmission assembly, Z19DTH , Automatic transmission assembly, Z19DTR or Manual gearbox assembly, Z19DTR .

2.	Aut : Remove the driver plate.

3.	Man : Remove Flywheel.

4.	Remove the oil sump, see Oil sump in car or Oil sump in car Z19DTR .

5.	Remove the bolts.

6.	Remove the crankshaft sealing ring.

To fit

1.	Clean the sealing surface.

2.	Fit the crankshaft sealing ring using 32 025 044 Fitting tool, crankshaft seal .

3.	Fit the bolts. Tightening torque 9 Nm (6 lbf ft).

4.	Fit the oil sump, see Oil sump in car or Oil sump in car Z19DTR .

5.	Man : Fit Flywheel .

6.	Aut : Fit the driver plate. Use Thread locking adhesive, Loctite 270 . Tightening torque 160 Nm (118 lbf ft)

7.	Fit the gearbox. See Manual gearbox assembly, Z19DT/DTH , Automatic transmission assembly, Z19DTH , Manual gearbox assembly, Z19DTR or Automatic transmission assembly, Z19DTR .

PRE-RELEASE

This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.

Our Friends