PRE-RELEASE
Body dimensions, CV
| Body dimensions, CV |
The following measurements can be used to determine whether the car should be mounted in an alignment jig. Detailed measurements can be obtained from the alignment jig manufacturer.
Illustration A shows correct measurement orientation
Illustration B shows incorrect measurement orientation
| Measurements, body front, above |
Body measurement values in the front, upper area of the CV are identical to the values for the 4D. See Body dimensions, 4D, 5D
| Body measurements, rear, above |
| Pos | Dimension, mm | Measuring points |
| 1 | 1127 | Distance between corners towards rear lamp |
| 2 | 715 | Corner towards the rear light - Corner of the opening for the striking plate |
(*) = centre of hole is starting point of measurement.
| Body measurements, side |
| Pos | Dimension, mm | Measuring points |
| 1 | 1202 | Rear hole of the upper hinge (*) - Upper hole of the striking plate (*) |
| 2 | 1241 | Rear hole, lower hinge (*) - Upper hole of the striking plate (*) |
| 3 | 4423 | Total length: front bumper member - rear bumper abutment (measured from the rear plate surface, not the welded bolt) |
(*) = centre of hole is starting point of measurement.
| Body measurements, front, inside |
| Pos | Dimension, mm | Measuring points |
| 1 | 861 | Outer hole, LH lock fitting (measured from below) (*) - Outer hole, RH lock fitting (measured from below) (*) |
| 2 | 290 | Outer hole, lock fitting (measured from below) (*) - Sill flange towards the corner of the seat bracket mounting |
| 3 | 1498 | Outer hole, lock fitting (measured from below) (*) - Sill flange towards the corner of the seat bracket mounting (diagonal measurement) |
| 4 | 1469 | Distance between flanges for sealing strips |
(*) = centre of hole is starting point of measurement.
| Body measurements, rear, inside |
| Pos | Dimension, mm | Measuring points |
| 1 | 1126 | Distance between rear holes, soft top mounting (*) |
| 2 | 1481 | Distance between the corners on the inside of the B-pillar |
| 3 | 1584 | Inside B-pillar corners - Corner of rear sill, towards the flange (diagonal measurement) |
| 4 | 1473 | Distance between flanges for sealing strips |
(*) = centre of hole is starting point of measurement.
| Body measurements, inner, front |
| Pos | Dimension, mm | Measuring points |
| 1 | 1407 | Rear hole, soft top mounting (*) - Outer hole, lock fitting (measured from below) (*) |
| 2 | 1717 | Rear hole, soft top mounting (*) - Outer hole, lock fitting (measured from below) (*) (diagonal measurement) |
| 3 | 1583 | Outer hole, lock (measured from below) (*) - Corner of rear sill, towards the flange (diagonal measurement) |
| 4 | 1417 | Hole, seat belt strap guide (*) - Corner, inner B-pillar (diagonal measurement) |
(*) = centre of hole is starting point of measurement.
| Body measurements, under |
Other measurements for under body, see Body dimensions, 4D, 5D .
| Pos | Dimension, mm | Measuring points |
| 1 | 1347 | Front mounting of subframe, centre of bolt head LH side - Hole in floor reinforcement RH side (*) |
| 2 | 1351 | Front mounting of subframe, centre of bolt head RH side - Hole in floor reinforcement LH side (*) |
(*) = centre of hole is starting point of measurement.
