PRE-RELEASE
SPA distance sensors
| SPA distance sensors |
| To remove |
| 1. |
Remove
Rear bumper shell
|
|
| 2. |
Detach the cellular plastic block from the lugs on the bumper shell.
|
|
| 3. |
Detach the sensor from the bumper shell by pressing out the locking tabs.
|
|
| 4. |
Unplug the sensor connector.
|
|
| 5. |
Remove the sensor seal.
|
|
| To fit |
When replacing, visible parts of the range finder and retainers shall be painted in the same colour as the bumper shell.
| Important | ||
|
The paint layer must not be thicker than 90μ. Otherwise, the function of the system could be affected. |
||
| 1. |
Fit the sensor seal.
|
|
| 2. |
Plug in the sensor connector.
|
|
| 3. |
Fit the sensor to the bumper shell.
|
|
| 4. |
Fit the cellular plastic block by feeding it in towards the bumper lugs. Press on the block.
|
|
| 5. |
Fit
Rear bumper shell
.
|
|
| Changing the sensor holder |
| 1. |
Remove the sensor.
|
|
| 2. |
Press out the decor strip locking tabs and remove the holders.
|
|
| 3. |
Fit the new holder to the decor strip.
|
|||||||
| 4. |
Fit the sensor.
|
|
