Control Solenoid Valve and Transmission Control Module Assembly Programming and Setup (6T70/6T75)
|
|
Control Solenoid Valve and Transmission Control Module Assembly Programming and Setup (6T70/6T75)
|
The following service procedures require either a programming or a setup event be performed for a complete repair. The transmission control module (TCM) is part of the control solenoid (w/body and TCM) valve assembly, and is not serviced separately.
|
Transmission Control Module (TCM) Replacement
|
If the TCM is replaced, the following procedures must be performed:
|
1.
|
|
Note
|
|
After programming, perform the following to avoid future misdiagnosis:
|
Turn the ignition OFF for 30 seconds.
|
|
2.
|
Turn the ignition to ON with the engine OFF.
|
|
3.
|
Use the scan tool in order to retrieve history DTCs from all modules.
|
|
4.
|
Clear all history DTCs.
|
|
Setup for Component Replacement
|
The replacement of some components will require a setup procedure for complete repair.
The
Transmission Adaptation Reset
procedure must be performed if any of the following components has been replaced:
|
•
|
Transmission Replacement
|
|
•
|
Any internal transmission repair
|
See
Transmission Adaptation Reset
.
