PRE-RELEASE
DTC B3607
| DTC B3607 |
| Diagnostic Instructions |
| • |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
|
| • |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
|
| • |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
|
| DTC Descriptor |
DTC B3607 4B
Adjustable Pedal Motor Circuit Calibration Not Learned
| Circuit/System Description |
After replacement of adjustable pedal mechanical components or if the memory seat control module is reprogrammed or replaced, the adjustable pedals softstop positions must be learned.
| Conditions for Running the DTC |
The memory seat control module must be powered.
| Conditions for Setting the DTC |
This DTC will set if the pedals actuator softstops are not learned.
| Action Taken When the DTC Sets |
Manual and memory adjustable pedals operation will be disabled.
| Conditions for Clearing the DTC |
| • |
The current DTC will become a history DTC when the fault is no longer present and the ignition has been cycled.
|
|
| • |
The history DTC will clear after 50 consecutive fault-free ignition cycles have occurred.
|
|
| Reference Information |
Schematic Reference
Adjustable Pedal Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Adjustable Pedals Description and Operation
Electrical Information Reference
| • |
Circuit Testing
|
|
| • |
Connector Repairs
|
|
| • |
Testing for Intermittent Conditions and Poor Connections
|
|
| • |
Wiring Repairs
|
|
Scan Tool Reference
Control Module References for scan tool information
| Circuit/System Verification |
| 1. |
Ignition ON, verify that no other adjustable pedal DTCs are set.
|
|
| 2. |
If other adjustable pedal DTCs are set, refer to
Diagnostic Trouble Code (DTC) List - Vehicle
.
|
|
| 3. |
Observe the scan tool Adjustable Pedals Softstop Learn Status parameter. The parameter reading should be learned.
|
|
| 4. |
If not the specified value, perform the scan tool Learn Adjustable Pedals Softstops procedure. Refer to
Adjustable Pedal System Calibration
. If the DTC resets, replace the K40 memory seat control module.
|
|
| Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for memory seat control module replacement, setup, and programming
