PRE-RELEASE
DTC B389A
| DTC B389A |
| Diagnostic Instructions |
| • |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
|
| • |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
|
| • |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
|
| DTC Descriptor |
DTC B389A 00
Environment Identification
| Circuit/System Description |
When certain modules are programmed and configured during installation, the module learns a specific environment identifier which is unique to the vehicle. The environment identifier is used to prevent the swapping modules between vehicles. The body control module (BCM) is the keeper of the environment identifier. The instrument cluster, electronic brake control module (EBCM), HVAC control module, sensing and diagnostic module (SDM), engine control module (ECM), and steering column lock control module, if equipped, each learn the environment identifier during their configuration process. During vehicle operation, each of these modules compare their environment identifier to that of the BCM. If the identifiers match, vehicle starting is allowed. If an environment identifier does not match, vehicle starting is disabled.
| Conditions for Running the DTC |
Ignition is in the ACCESSORY or RUN position.
| Conditions for Setting the DTC |
An incorrect environment identifier is stored by the BCM.
| Action Taken When the DTC Sets |
| • |
The security indicator in the instrument cluster will illuminate.
|
|
| • |
Vehicle starting will be disabled.
|
|
| Conditions for Clearing the DTC |
A current DTC will be cleared when the BCM learns a correct environment identifier.
| Diagnostic Aids |
If BCM programming is not properly completed after BCM replacement, the environment identifier will not be properly learned. If DTC B389A sets immediately after the replacement and programming of a BCM, perform the programming procedure again.
| Reference Information |
Schematic Reference
Immobilizer Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Immobilizer Description and Operation
Electrical Information Reference
| • |
Circuit Testing
|
|
| • |
Connector Repairs
|
|
| • |
Testing for Intermittent Conditions and Poor Connections
|
|
| • |
Wiring Repairs
|
|
Scan Tool Reference
Control Module References for scan tool information
| Circuit/System Verification |
| 1. |
Verify DTC B389A did not set immediately following the replacement and programming of a BCM.
|
|
| 2. |
If the DTC set immediately after the replacement and programming of a BCM, the immobilizer learn procedure was not properly completed. Perform the BCM immobilizer learn using the Body Control Module IMMO Function with Existing Transponder or Remote Key in SPS. Refer to
Immobilizer System Component Programming
.
|
|
| 3. |
Verify DTC B3902 is not set in the any of the following control modules:
|
|
| • |
ECM
|
| • |
SDM
|
| • |
EBCM
|
| • |
HVAC control module
|
| • |
Instrument cluster
|
| • |
Steering column lock control module, if equipped
|
| 4. |
If DTC B3902 is set in any of the modules, refer to
DTC B3902
.
|
|
| 5. |
Perform the BCM immobilizer learn using Body Control Module IMMO Function with Existing Transponder or Remote Key in SPS. Refer to
Immobilizer System Component Programming
. Verify DTC B389A does not set after programming.
|
|
| Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for K9 BCM replacement, programming, and setup
