PRE-RELEASE
DTC P0633
| DTC P0633 |
| Diagnostic Instructions |
| • |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
|
| • |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
|
| • |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
|
| DTC Descriptor |
DTC P0633
Immobilizer Key Not Programmed
| Circuit/System Description |
When learning the immobilizer data, as well as the challenge and response sequence, the engine control module (ECM) is placed in learn mode. T DTC P0633 will be registered automatically as an indicator that the system is in learn mode and not as a fault indicator. Once the immobilizer data and challenge/response are learned, learn mode will be exited when the engine is successfully started. If the ECM does not exit learn mode, DTC P0633 will remain current and indicate a fault.
| Conditions for Running the DTC |
The ECM is in learn mode.
| Conditions for Setting the DTC |
DTC P0633 will set any time the ECM enters learn mode.
| Action Taken When the DTC Sets |
The security indicator in the instrument cluster will illuminate.
| Conditions for Clearing the DTC |
| • |
A current DTC P0633 will be cleared upon a successful engine start after exit of learn mode.
|
|
| • |
A history DTC will be cleared after 100 malfunction-free ignition cycles or when a scan tool is used to clear DTCs.
|
|
| Diagnostic Aids |
The key referenced in the DTC descriptor does not refer to the vehicle key. In this case, key is referring to the challenge response.
| Reference Information |
Schematic Reference
Immobilizer Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Immobilizer Description and Operation
Electrical Information Reference
| • |
Circuit Testing
|
|
| • |
Connector Repairs
|
|
| • |
Testing for Intermittent Conditions and Poor Connections
|
|
| • |
Wiring Repairs
|
|
Scan Tool Reference
Control Module References for scan tool information
| Circuit/System Verification |
| Note | ||
| • |
Because of normal system communications between the BCM and ECM, any immobilizer DTCs set in the BCM must be diagnosed prior to the diagnosis of immobilizer DTCs set in the ECM.
|
|
| • |
DTC P0633 will clear upon a successful engine start. Any malfunction that will cause a no-start condition will prevent DTC P0633 from clearing. Prior to diagnosing DTC P0633, ensure that all power moding and engine control systems are operating properly and all conditions that may cause a no-start have been corrected.
|
|
Perform the ECM immobilizer learn using the engine control module IMMO learn function in SPS. Refer to Immobilizer system component programming . The ECM should successfully complete the password learn and the vehicle should start.
| Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for ECM replacement, setup, and programming
