PRE-RELEASE
DTC P1631
| DTC P1631 |
| Diagnostic Instructions |
| • |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
|
| • |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
|
| • |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
|
| DTC Descriptor |
DTC P1631
Immobilizer Fuel Enable Signal Not Correct
| Circuit/System Description |
The body control module (BCM) sends the pre-release information to the engine control module (ECM) via the serial data circuit. The ECM then sends a challenge to the BCM. Both the ECM and BCM perform a calculation on this challenge. If the calculated response from the BCM equals the calculation performed by the ECM, the ECM will allow vehicle starting. The BCM follows this action by sending the remaining immobilizer data to the ECM. If the immobilizer data sent by the BCM matches that stored by the ECM, the ECM will allow the engine to remain running.
| Conditions for Running the DTC |
Ignition is in the ACCESSORY or RUN position.
| Conditions for Setting the DTC |
The ECM receives incorrect immobilizer data from the BCM.
| Action Taken When the DTC Sets |
| • |
The security indicator in the instrument cluster will illuminate.
|
|
| • |
Vehicle starting will be disabled.
|
|
| Conditions for Clearing the DTC |
| • |
A current DTC P1631 will be cleared when correct immobilizer data is received.
|
|
| • |
A history DTC will be cleared after 40 malfunction-free ignition cycles or when a scan tool is used to clear DTCs.
|
|
| Reference Information |
Schematic Reference
Immobilizer Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Immobilizer Description and Operation
Electrical Information Reference
| • |
Circuit Testing
|
|
| • |
Connector Repairs
|
|
| • |
Testing for Intermittent Conditions and Poor Connections
|
|
| • |
Wiring Repairs
|
|
Scan Tool Reference
Control Module References for scan tool information
| Circuit/System Verification |
| Note | ||
|
Because of normal system communications between the BCM and ECM, any immobilizer B-codes must be diagnosed prior to the diagnosis of P-codes. |
Perform the BCM immobilizer learn using the body control module IMMO function with existing transponder or remote key in SPS. Refer to Immobilizer system component programming . The BCM should successfully complete the learn and the vehicle should start.
